053Auto Focus typeYou can select your preferred Focus Area according to the shootingconditions.[Center AF] ( ) : The rectangular area in thecenter of the LCD monitorwill be focused[Multi AF] ( ) : This camera selects all ofavailable AF point from the 9AF points.[Selection AF] ( ) : Focus on the desired position of the LCD monitor.[Tracking AF] ( ) : The focus moves along with the movements of asubject.Ä When the camera focuses on the subject, the auto focus frameturns to green. When the camera doesn't focus on the subject, theauto focus frame turns to red.Functions ( )Ŷ How to Enable Selection AFAfter setting [Selection AF], press the OKbutton and then the screen for setting thelocation of a focus frame will appear.Press the Up/Down/Left/Right button tomove the focus mark to the desired position.Press the shutter button to enable SelectionAF. Once setting is complete, the focus markwill be ¿xed at the position set.Press the OK button once again to change the location of the focusframe and the focus frame will appear again.Ä Even if you turn off the power and turn on it again, the previous set-ting will be maintained.Ä [Selection AF] is not available when operating the [Face Detection]function.Focus MarkFlash IntensityYou can control Àash intensity. (You can set Àash intensity within therange of +/- 2EV in intervals of 1EV.)[-2], [-1], [0], [+1], [+2]Ɣ The [Flash EVC] function is not available in the [Smart Auto],[Beauty Shot], [Scene] and [Movie], [Night] modes.Ɣ If the subject is too close or the sensitivity is too high, changingthe value to a negative value (-) may not have any effect.Ɣ If the Àash intensity is out of the control range because theexposure value is too high or low, the camera may not operateproperly.Focus AreaBack Move-2 -1 0 +1 +2Flash EVCBack Move