Samsung WF210 series User Manual

Also see for WF210 series: User manual User manual User manual

setting up your washer _13MEETING INSTALLATION REQUIREMENTSElectrical supply• 120 Volt 60 Hz 15 AMP fuse or circuit breaker• Individual branch circuit serving only your Washer is recommended.• Your Washer is equipped with a power cord.Never use an extension cord.GroundingELECTRICAL GROUNDING IS REQUIRED FOR THIS APPLIANCE.This appliance must be grounded. In the event of malfunction or breakdown, grounding willreduce the risk of electric shock by providing a path of least resistance for electric current.This appliance is equipped with a power cord having a three-prong grounding plug for use in aproperly installed and grounded outlet.The plug must be plugged into an appropriate outlet that is properly installed and grounded inaccordance with all local codes and ordinances.Improper connection of the equipment-grounding conductor can result in a risk of electricalshock. Check with a qualified electrician or serviceman if you are in doubt as to whetherthe appliance is properly grounded. Do not modify the plug provided with the appliance. If itdoes not fit the outlet, have a proper outlet installed by a qualified electrician.IMPORTANT SAFETY PRECAUTIONS• To prevent unnecessary risk of fire, electrical shock or personal injury, all wiring andgrounding must be done in accordance with the National Electrical Code ANSI/FNPA, No.70 Latest Revision and local codes and ordinances. It is the personal responsibility of theappliance owner to provide adequate electrical service for this appliance.Never connect ground wire to plastic plumbing lines, gas lines, or hot water pipes.WaterTo correctly fill your washer in the proper amount of time, water pressure of 20-116psi (137-800kPa) is required.Water pressure less than 20 psi (137kPa) may cause water valve failure, or may not allow thewater valve to shut off completely. Or, it may extend the fill time beyond what your washercontrols allow, resulting in your washer turning off. A time limit is built into the controls in theevent of an internal hose becoming loose and flooding your home.The water faucets must be within 4 ft.(122cm) of the back of your washer for the inlet hosesprovided with your washer.Accessory inlet hoses are available in various lengths up to 10 ft.(305cm) for faucets thatare further away from the back of your washer.To avoid the possibility of water damage:• Have water faucets easily accessible.• Turn off faucets when the washer is not in use.• Periodically check that there is no leakage from the water inlet hose fittings.Check all connections at the water valve and faucet for leaks.Drain facilityThe recommended height of the standpipe is 18 in (46 cm). The drain hose must be routedthrough the drain hose clip to the standpipe. The standpipe must be large enough to accept theoutside diameter of the drain hose. The drain hose is attached at the factory.01 SETTING UP YOUR WASHERCAUTIONCAUTIONWARNINGWARNINGWF210AN-02832A-08_EN.indd Sec5:13WF210AN-02832A-08_EN.indd Sec5:13 2012-07-27 4:37:042012-07-27 4:37:04