Samsung WF210 series User Manual

Also see for WF210 series: User manual User manual User manual

setting up your washer _172. Before connect the inlet hoses to water faucets, check toensure a washer is inside each coupling on both ends.3. Check the inlet hose to ensure a washer is inside each fillhose coupling.Thread the inlet hoses to the HOT and COLD faucetconnections on the washer.On the other end of the hose, check for one rubber washerper hose and attach each fill hose to the water valve. Makesure the hose with the Hot printed line is attached to theHOT faucet. Tighten by hand until snug, then two-thirds of aturn with pliers.For correct water use, connect both HOT and COLD watervalves. If either or both are not connected, an “nF” (no fill)error can occur.4. Turn on the HOT and COLD water supply and check allconnections at the water valve and the faucet for leaks.5. Plug the power cord into a 3-prong, well grounded 120 volt60 Hz approved electrical outlet protected by a 15-amp fuseor comparable circuit breaker.Your washer is grounded through the third prong of the powercord when plugged into a three-prong grounded receptacle.6. Slide your washer into position.7. Level your washer by turning the leveling legs in or out asnecessary by hand or by using the wrench included with yourwasher.When your washer is level, tighten the locking nuts using thewrench or (-) flathead screwdriver.Your washer must be leveled on all four sides. A carpenter’slevel should be used on all four corners of your washer. It’sthe best to recheck after the first dozen washes.Avoid damage to the legs. Do notmove the washer unless the locking-nuts are fastened to the bottom of thewasher.01 SETTING UP YOUR WASHERRubberWasherCouplingCold HotCold printed Hot printedWF210AN-02832A-08_EN.indd Sec5:17WF210AN-02832A-08_EN.indd Sec5:17 2012-07-27 4:37:052012-07-27 4:37:05