22_ washing a load of laundrySpin OnlyIf you press the Power button and then press and hold the Spin button for 2 seconds, the spintime will be displayed on the display panel.Then, press the Spin button repeatedly until the required spin level is selected, and then pressthe Start/Pause button.Before pressing the Spin Only button to use the Spin Only function, you can select a cyclewith the Cycle Selector. If you have selected a cycle, you can only select the spin levelcorresponding to the selected cycle.Garment+You can add or take out laundry items even after the wash has started, as long as the“Garment+ ” light is turned on. Pressing the Start/Pause button unlocks the door, unless thewater is too hot or if there is too much water in your washer. If you are able to unlock the doorand wish to continue the wash cycle, close the door, and then press the Start/Pause button.My cycle (WF210*)Allows you to activate your custom wash (temperature, spin, soil level, etc.) with one–buttonconvenience.By pushing the My Cycle button, you activate the settings used during the My Cycle mode. The“My Cycle” llight indicates activation.You can select all options as follows in the My Cycle mode.1. Select cycles using the Cycle Selector.2. After cycle selection, set each option.See page 37 for available option settings with each cycle.3. Then, you can store the cycle and options you select by pressing the Start/Pause buttonin the My Cycle mode. The cycle and options you select are displayed the next time youchoose the My Cycle function.• You can change the My Cycle settings by repeating the process above.The last used setting is displayed the next time you choose the My Cycle function.• If washing is completed in My Cycle mode, the washing machine automatically entersMy Cycle mode when you turn the power on by pressing the Power button.washing a load of laundryWF210AN-02832A-08_EN.indd Sec3:22WF210AN-02832A-08_EN.indd Sec3:22 2012-07-27 4:37:062012-07-27 4:37:06