28_ cleaning and maintaining your washercleaning and maintaining yourwasher5. Wash any dirt or other material from the debris fi lter. Make surethe drain pump propeller behind the debris fi lter is not blocked.6. To assemble the fi lter cap, align the projected part of the fi lter capto your 12 o’clock (on an imaginary clock) and turn it clockwise.7. Replace the debris fi lter cap.8. Replace the fi lter cover.CLEANING THE DOOR SEAL/BELLOW1. Open the washer door and remove any clothing or items from the washer.2. Inspect the gray colored seal/bellow between the dooropening and the basket for stained areas. Pull back theseal/bellow to inspect all areas under the seal/bellow and tocheck for foreign objects.3. If stained areas are found, wipe down these areas of the seal/bellow, using the procedurethat follows.a) Mix a dilute solution, using ¾ cup (177 mL) of liquid chlorine bleach, and 1 gal. (3.8 L) ofwarm tap water.b) Wipe the seal/bellow area with the dilute solution, using a damp cloth.c) Let stand 5 minutes.d) Wipe down area thoroughly with a dry cloth and let the washer interior air dry with dooropen.IMPORTANT:• Wear rubber gloves when cleaning for prolonged periods.• Refer to the bleach manufacturer’s instructions for proper use.PRESERVING THE TOP COVER AND THE FRONT FRAMEDo not place any heavy or sharp objects or a detergent box on the washer. Keep them on the purchasedpedestal or in a separate storage box.This may scratch or damage the top cover. And there are dangers for drop.Since the entire washer has a high-gloss fi nish, the surface can be scratched or damaged. Therefore,avoid scratching or damaging the surface when using the washer.CAUTIONseal/bellowWF419AA-02657G-03_EN.indd Sec7:28WF419AA-02657G-03_EN.indd Sec7:28 2011-06-22 ¿ÀÈÄ 4:09:522011-06-22 ¿ÀÈÄ 4:09:52