Wireless network setup2312. Using a Network-Connected MachineUsing SyncThru™ Web ServiceBefore starting wireless parameter configuration, check the cable connectionstatus.1 Check whether or not the network cable is connected to the machine. Ifnot, connect the machine with a standard network cable.2 Start a web browser such as Internet Explorer, Safari, or Firefox and enteryour machine’s new IP address in the browser window.For example,3 Click Login on the upper right of the SyncThru™ Web Service website.4 Type in the ID and Password then click Login. We recommend you tochange the default password for security reasons.• ID: admin• Password: sec000005 When the SyncThru™ Web Service window opens, click NetworkSettings.6 Click Wireless > Wizard.Wizard will help you setup the wireless network configuration. However, ifyou want to set the wireless network directly, select Custom.7 Select the one Network Name(SSID) in the list.• SSID: SSID (Service Set Identifier) is a name that identifies a wirelessnetwork, access points, and wireless devices attempting to connectto a specific wireless network must use the same SSID. The SSID iscase sensitive.• Operation Mode: Operation Mode refers to the type of wirelessconnections (see "Wireless network name and network password"on page 195).- Ad-hoc: Allows wireless devices to communicate directly witheach other in a peer-to-peer environment.- Infrastructure: Allows wireless devices to communicate witheach other through an access point.If your network’s Operation Mode is Infrastructure, select the SSID of theaccess point. If the Operation Mode is Ad-hoc, select the machine’s SSID.8 Click Next.If the wireless security setting window appears, enter the registeredpassword (network password) and click Next.
