Sanyo DP42746 Owner's Manual

Also see for DP42746: Quick and easy setup Connection guide Service manual

Sanyo DP42746 Owner's Manual Manual pdf 8 page image

When the television is powered on for the firsttime, it automatically checks for the presence ofan RF signal.• Press the POWER key to turn on theDTV.• Then press the CHANNEL UP(CH ) key to automaticallysearch for available channels:Digital (ATSC) and Analog (NTSC).The All Channel Search contains two processes that areexecuted simultaneously for digital and analog channels.NOTES: Channel information found during All Channel Search isstored in two Channel Scan Memory databases(Analog and Digital). After all channel search is com-pleted, the TV will tune to the lowest Digital channel orlowest Analog channel if no digital channels are found.If the TV does not detect any digital or analog channels,a message advising the viewer to check the cables andantenna connections will appear. In this case, youmust press the CHANNEL UP key again to repeat thechannel search process. If after two searches the TVstill fails to detect any channels, the TV will tune toanalog channel 3.If no analog or digital channels are found after thesecond search, All Channel Search will default to off-air analog channels 2 through 69 and digital channelD3-1. Select analog channels using the remote controlkeypad. See page 16, item number 2.4 ALL CHANNEL SEARCHIMPORTANT NOTE: Spent or dis-charged batteries must be recycled ordisposed of properly in compliancewith all applicable laws. For detailedinformation, contact your local CountySolid Waste Authority.2 INSTALL BATTERIES• Install two “AAA” Batteries (not included) so that the“+” and “–” marks on the batteries match the “+” and“–” marks inside the Remote.To review the remote control functions, go topages 16 ~17.NOTE: Use two “AAA” Alkaline batteries.3 CONNECT AC POWER CORD• Connect AC Power Cord (supplied) to the Plasma TVand electrical outlet as shown here.The AC outlet must be near this equipment and must beeasily accessible.To POWER CORDCONNECTOR on backof Plasma TV.To 120 V AC outlet.5 ANTENNA SIGNAL SELECTION(OPTIONAL)To change the initialanalog tuning systemsetup (from antenna tocable or cable toantenna), use the on-screen menu. See“Analog Antenna Sig-nal” on page 20.8 Need help? Visit our Web site at www.sanyoctv.com or Call 1-800-877-5032FIRST-THINGS-FIRST (Required Initial Setup)SKIP THE CHANNEL SEARCH PROCESSUse this featureonly if the DTV is used primarily forplaying video games, or watching videos, or if you receivelocal channels from a satellite receiver or cable system.• Press the EXIT key to cancel the channel searchprocess.• The DTV will be tuned to Analog Channel 3.• Press the INPUT key (remote control) to selectAV signal source connected to: Video 1, Video 2,Video 3, or HDMI jacks.