Sanyo DSR-2108 Instruction Manual

Contents

Sanyo DSR-2108 Instruction Manual Manual pdf 21 page image

14Operating the PTZ dome cameraPan/Tilt, Zoom/Focus operations are possible from this unit when a coaxial superimposed type (COAX) camera is connected, or aPTZ dome camera is connected using the RS-485 control terminal. Operation may not be possible depending on the connectedcamera.When connecting other than a coaxial superimposed type(COAX) camera, connect the RS-485 control terminal of thisunit and that of the camera using a twisted pair cable.Refer to "Connecting the RS-485 control terminal (P6)".1 Press the MENU button (the MAIN MENU isdisplayed) and select "SYSTEM" using the controlbutton (}~).• A password is requested when pressing the MENUbutton. Enter the ADMIN PASSWORD. (P38)2 Place the cursor on "PTZ CONTROL" and press theENTER button.The PTZ screen is displayed.3 Point the cursor to "DATA SPEED" and set thecommunication speed.The set speed is applied to all channels except forSANYO protocol.Set the communication speed for the SANYO protocolusing RS485 SET. (P40)4 Point the cursor to "CHANNEL", specify thechannel and set the "PROTOCOL" and "ADDRESS".PROTOCOL: Selecting the type of protocolADDRESS: Camera ID (0 - 63)5 Press the EXIT/STOP button once the settings arecomplete.1 Select the number of the PTZ dome cameraconnected using the camera selection button.2 Press the PTZ button.The control screen is displayed.3 Controlling the cameraControl functions available differ according to thecamera model.b Pan/Tilt operations1 Select "PAN/TILT" using the control button ({|)and press the ENTER button.2 Adjust the tilt position using the control button ({|)and adjust the pan position using the control button(}~).3 To perform automatic panning press the ENTERbutton.• The following message is displayed on the screen.Up/Down key: Tilt Up/DownLeft/Right key: Pan Left/RightEnter key: Auto Panb Zoom/Focus operations1 Select "ZOOM/FOCUS" using the control button({|) and press the ENTER button.2 Adjust the zoom using the control button ({|) andadjust the focus position using the control button(}~).3 To activate the auto focus press the ENTER button.• The following message is displayed on the screen.Up/Down key: Zoom In/OutLeft/Right key: Focus Near/FarEnter key: Auto Focus1 Connection2 SettingsWhen connecting multiple cameras to the RS-485 controlterminal, set the same protocol for all cameras except forthose cameras connected with SANYO protocol.SYSTEMDVR ID DVRDESCRIPTIONLOAD DEFAULTADMIN PASSWORDUSER PASSWORDNETWORK PASSWORDDATE FORMAT YYYY/MM/DDCLOCK SETRS485 SETPTZ CONTROLLANGUAGE ENGLISHREMOTE CONTROL ID 00MAIN MENURECORDLIVE SYSTEMHDD SETNETWORK SERVICEDATA SPEED 9600CHANNEL 1PROTOCOL - - - -ADDRESS 1PTZ113 OperationPAN/TILTZOOM/FOCUSIRIS/TOUR/SEQUENCEMENU2009/05/03 09:04:542%:A