Sanyo DSR-2108 Instruction Manual

Contents

Sanyo DSR-2108 Instruction Manual Manual pdf 24 page image

Recording171 Recording starts automatically when this unit isturned on."C" is displayed on the screen. The connected camerasare simultaneously recorded.The recording mode can be changed usingRECORDING under RECORD settings. Settings, suchas image quality, can also be set. (P35)2 To stop recording, select "RECORDING" underRECORD settings using the control button ({|) andselect "DISABLE" using the control button (}~).“C” disappears.A motion sensor can be set for each channel.1 Adjusting the following settings using the controlbutton ({|}~).2 Select "RECORDING" using the control button({|) and select "MOTION" using the controlbutton (}~).3 Select "MOTION ZONE" using the control button({|) and select the "PARTIAL ZONE" using thecontrol button (}~), press the ENTER button.The motion setting screen is displayed.4 Select the sensor detection position using thecontrol button ({|}~) and press the ENTERbutton.The frame set for the sensor detection is grainy.Select a sensor detection position by repeating theoperation.Once the setting of the event searched is complete,press the EXIT/STOP button to return to the RECORDscreen.5 Select "MOTION SENSITIVITY" using the controlbutton ({|) and select the level of sensitivityusing the control button (}~).Selections: 1-9 (Low sensitivity)6 Select "PRE RECORD" using the control button({|) and select the pre recording as necessaryusing the control button (}~).7 Select "POST EVENT RECORD" using the controlbutton ({|) and select the recording time asnecessary using the control button (}~).Selections: 2 - 30 SECONDS, 1 - 5 MINUTES,10 MINUTES, 15 MINUTES8 Press the EXIT/STOP button once operations arecomplete.Press the EXIT/STOP button repeatedly to return to thelive video.B CONTINUOUS recordingC MOTION recording• RESOLUTION• CHANNEL• FRAME RATE• QUALITYCH1 CCH3CH2CH42009/05/03 09:04:542%:ACCCRECORDRESOLUTION FULLCHANNELFRAME RATE 1 ipsQUALITY NORMALRECORDING CONTINUOUSMOTION ZONE FULL ZONEMOTION SENSITIVITY 9ALARM RECORDING -- -- -- --PRE RECORD OFFPOST EVENT RECORD 5 SECONDSAUDIO OFFTIMER SETREAL-TIME REC SET11• PARTIAL ZONE • FULL ZONEIf "FULL ZONE" is selected, the motion setting screen isnot displayed. Only set the level of sensitivity for MOTIONSENSITIVITY.RECORDRESOLUTION FULLCHANNEL CFRAME RATE 1 ipsQUALITY NORMALRECORDING MOTIONMOTION ZONE PARTIAL ZONEMOTION SENSITIVITY 9ALARM RECORDING -- -- -- --PRE RECORD OFFPOST EVENT RECORD 5 SECONDSAUDIO OFFTIMER SETREAL-TIME REC SET11Detectionframe