RECORD SET366 EnglishSETTINGS3 Set “ALARM RECORDING AREA” to49% and turn the shuttle dial to theright.The cursor moves to “AREA FULL RESET.”4 Turn the shuttle dial counter- clockwise.The screen is displayed. The screencontains a message regarding initialization of the harddisk.5 To change the recording area, turn thejog dial to display “YES”.z If the shuttle dial is turned clockwise while “NO” isselected, the screen willbe displayed and the recording capacities will revert totheir previous settings. In other words, the new settingswill not be adopted.6 Turn the shuttle dial clockwise.(1) The hard disk is initialized.(2) The screen appears and themodified recording capacities are adopted.7 Press the [EXIT/OSD] button.The setting procedure is ended and the display returns tothe normal screen.Set whether to continue recording and automaticallyoverwrite data, or stop recording and not overwrite datawhen the normal recording area and alarm recording areabecome full (Setting recording conditions (JP.67)). Defaultsetting is to automatically overwrite.If the setting to not overwrite is selected, recording stops atthe point where remaining capacity runs out. In this case,recording can be continued using the following steps toauthorize overwriting.Also, data is not overwritten automatically to archive area.Follow the steps below to authorize overwriting each timedata is full.1 Set the items in “Setting overwriting forthe normal recording area”. (JP.67)Set “OVERWRITE” to “OFF.”TOTAL CAPACITY : 82GBNORMAL RECORDING AREA : 50 %AREA FULL RESET ->ALARM RECORDING AREA : 49 %AREA FULL RESET ->ARCHIVE AREA : 1 %AREA FULL RESET ->CAUTION : WHEN THE AREA SETTING IS CHANGED,THE WHOLE AREA WILL BE INITIALIZED !THIS CHANGE WILL INITIALIZE THE DISK.ALL RECORDING WILL BE ERASED.ARE YOU SURE ?NOCHANGE:JOG SET:SHUTTLETHIS CHANGE WILL INITIALIZE THE DISK.ALL RECORDING WILL BE ERASED.ARE YOU SURE ?YESCHANGE:JOG SET:SHUTTLESetting overwrite permissionHDD INITIALIZING !EXIT/OSD
