|
GENERAL SET4English 872 Turn the jog dial to select “1. DISPLAYSET”, and then turn the shuttle dialclockwise.The screen is displayed.3 Turn the shuttle dial clockwise.“ON” for the (1) “DATE” flashes. This can be set to “OFF”turning the jog dial to remove the date from the operationdisplay area.4 Turn the shuttle dial clockwise.The cursor moves to the time entry.The following settings are carried out with the shuttledial and jog dial.z Vertical cursor movement: Turn the jog dial.z Cursor movement to the right: Turn the shuttle dialclockwise.z Modification of values: Turn the shuttle dial clockwise,and then with the setting value flashing, turn the jogdial.z Confirmation of values: Turn the shuttle dial clockwise.5 Perform the following if so required.z TIME (OFF):Time is not displayed during recording or playback.z QUALITY (OFF):Picture quality mode is not displayed during recordingor playback.z AUDIO (OFF):Audio recording settings are not displayed duringrecording or playback.z ALARM COUNT (OFF):The current number of alarms is not displayed.z ALARM TYPE (OFF):The type of alarm recording is not displayed.z TITLE (OFF):Camera titles are not displayed. The content of the operation display areachanges when the setting for “ALARMRECORDING” (JP.77) from MODE SET> is switched.When turned “OFF”:The alarm count and type are not displayed.When turned “ENABLED”:The operation display area changes as follows.z “ALARM” is displayed when alarm video is recorded orplayed back.z “PRE” is displayed when pre-alarm video is recorded orplayed back.z “ARCHIV” is displayed for playback from the archive area.6 Press the [EXIT/OSD] button.The setting procedure is ended and the display returns tothe normal screen.z A maximum of 9,999 alarms can be displayed in theoperation display area. When this number is exceeded,the count returns to 0000.\Use the following procedure to display “VIDEO LOSS!”when the camera video is interrupted.1 Turn the jog dial to select “VIDEOLOSS”, and then turn the shuttle dialclockwise.2 Turn the jog dial to display “ON”, andthen turn the shuttle dial clockwise.3 Press the [EXIT/OSD] button.The setting procedure is ended and the display returns tothe normal screen.DATE : ONTIME : ONQUALITY : ONAUDIO : ONALARM COUNT : ONALARM TYPE : ONTITLE : ONVIDEO LOSS : ON01-01-04 00:00:00 REC 1% EN A ALARM 000002(1) (2)(3) (4)(5) (6)(7)(1) (2) (6)(3)(4) (5)(7)Setting display for video lossEXIT/OSDDATE : ONTIME : ONQUALITY : ONAUDIO : ONALARM COUNT : ONALARM TYPE : ONTITLE : ONVIDEO LOSS : ONEXIT/OSD
|
