Sanyo FW32D08F Manual

Also see for FW32D08F: Start guide

These operations are accessible by remote control.Some may also be accessible by the main unit's controlpanel.Initial setupThis section will guide you through the unit’s Initial setting which includesselecting a language for your On-screen menu and Autoprogram, whichautomatically scans and memorizes viewable channels.Before you begin:Make sure the unit is connected to an antenna or cable.1 After making all the necessary connections, press B to turn on theunit.● It may take a few moments to turn on the unit for the first time.● Initial setup menu appears automatically after the unit is turnedon.2 Use H I to select the On-screen language from the choices(English / Español / Français) on the right side of the TV screen,then press OK.3 Use H I to select Voice guide to Off or On on the right side of theTV screen, then press OK.4 Use H I to select Antenna for TV channels or Cable for CATVchannels, then press OK.SkipBackOKSelectSkipCableAntennaANTENNA INOrCableAntennaSelect your signal source.jack.Make sure the antenna is connected to "ANTENNA IN"Initial setup– When Antenna is selected, the TV detects antenna signals. Itsearches for DTV and analog TV channels available in your area.– When Cable is selected, the TV detects signals supplied bycable. It searches for DTV, analog TV and cable channelsavailable in your area.● Autoprogram will begin.Skip0 chAnalog channels0 chDigital channels0%complete.Auto programming may take more than 20 minutes toPlease wait while the system is scanning for channels.Initial setup5 Use H I to select the desired location setting, then press OK.Home is the ENERGY STARN qualified setting.OKSelectHomeRetailInitial setupDemo with fixed settings.“Retail” mode is optimized for Storeusage for home use.and is optimized for efficient energy“Home” mode is Energy Star qualifiedLocation:● Select Home, the unit is set to maximize the energy efficiency forhome setting and it can be adjusted through a choice of pictureand sound quality according to your preference. Use this settingto remove the E-sticker, if visible on the display. L p. 30● You must set Home in step 5. Otherwise, Picture and Soundsettings you adjusted will not be memorized after the unit goesinto standby mode.● When the Initial setup is completed, the lowest memorizedchannel with the confirmation message of the location setting willbe displayed on the TV screen.● Select Retail, the unit will be set up with predefined settings forretail displays. In this setting, the power consumption maypossibly exceed the limited requirement limit of the ENERGYSTARN qualification.Note(s)● If you are not receiving a signal from your cable service, contact the cable provider.● If you press B or MENU during Autoprogram, this setup of TV channels will be cancelled.● The initial Autoprogram function can be executed for either Antenna or Cable only once.When you change the connection (Antenna / Cable), select Autoprogram again.L p. 23● If there is no signal input from the antenna terminal and no operation for several secondsafter you turn on the unit, helpful hints appears. Follow the instructions listed on the TVscreen.SkipOKSelectLaterRetryInitial setup########the appropriate source input.press "SOURCE" key on the remote control to selectthe input which you have connected to the box andIf you are using a cable or satellite box, please confirminstallation process searches this connection.ANTENNA IN jack on the back of the TV, the channelVerify that you have a cable connected to theTry Autoprogram again?No channel is registered.After an initial setup is completed...● If you want to scan the channels automatically again.Autoprogram L p. 23● You can add the desired cable and analog channels not memorized byAutoprogram.Add channels L p. 24● If you want to change to another language.Language L p. 30● If you want to change the location setting.Location L p. 3015 .English