Sanyo FW32D08F Manual

Also see for FW32D08F: Start guide

SoundBefore you begin:You must set Location to Home. L p. 30Otherwise, personalized picture and sound settings will not be memorizedafter the unit goes into standby mode.1 Press MENU and use H I to select Sound, then press OK.USBLanguageFeaturesSetupSoundPictureStereoMultichannelOnOffOnStandardPrimary MTSDigital output formatTV speakersAuto volume levelingVirtual surround soundEqualizerAuto sound2 Use H I J K to select the item you want to adjust, then press OK.Auto soundTo select the desired setting, then press OK.(Personal, Standard, Vivid, Sports, Movie, Musicor News)When you adjust the following settings (Equalizer,Virtual surround sound or Auto volume leveling),Personal sound will be set automatically whenLocation is set to Home.Adjust the tonal quality for each frequency.EqualizerCursor I Cursor HTo adjust each level of tonal quality.Press BACK to go back to the previous menu.Virtual surround sound gives you the stereophonic virtual space through yourexisting 2-channel stereo system.Virtual surroundsoundOff Natural effectOn Emphasized effectThis function keeps a constant loudness level between the TV commercialsand the programs.Auto volumelevelingOff To remove the Auto volumelevelingOnTo reduce volume differencesbetween the TV commercials andthe programsYou can select the audio output from the unit’s speakers or not. If youramplifier is HDMI link function compatible and connected by an HDMI cableto this unit, some sound operations such as volume up can be changed byusing this unit’s remote control.TV speakersOn To output sound from the unit’sspeakersOff No output sound from the unit’sspeakersCEC LinkTo control audio output from yourconnected HDMI-CEC compliantdevices with VOL + / – by using thisynit's remote control.You can select audio output through a digital audio output connector.Digital outputformatMultichannelTo output multichannel signals(When the audio of the content isPCM, it will be output in PCM evenif Multichannel is selected.)PCM To output PCM formatYou can set the output mode as a default for the sound mode (Analog TVonly).This setting is not interlocked when you change the output mode by pressingSAP. Refer to Switching audio mode. L p. 17Primary MTSStereo To output stereo audioMono To output mono audioSAP To output second audio programNote(s)● When Digital output format is configured for Multichannel output while content with Multichannelaudio is being played, Voice guide ( L p. 24) is not contained in the output.22 .EnglishContinued on next page.