Sanyo FW32D08F Manual

Also see for FW32D08F: Start guide

Important safety instructionsRead these instructions.Keep these instructions.Heed all warnings.Follow all instructions.Do not use this apparatus near water.Clean only with dry cloth.Do not block any ventilation openings. Install inaccordance with the manufacturer’s instructions.Do not install near any heat sources such as radiators,heat registers, stoves, or other apparatus (includingamplifiers) that produce heat.Do not defeat the safety purpose of the polarized orgrounding-type plug. A polarized plug has two bladeswith one wider than the other. A grounding type plughas two blades and a third grounding prong. The wideblade or the third prong are provided for your safety. Ifthe provided plug does not fit into your outlet, consultan electrician for replacement of the obsolete outlet.Protect the power cord from being walked on orpinched particularly at plugs, convenience receptacles,and the point where they exit from the apparatus.Only use attachments / accessories specified by themanufacturer.Use only with the cart, stand, tripod,bracket, or table specified by themanufacturer, or sold with theapparatus. When a cart is used, usecaution when moving the cart /apparatus combination to avoid injuryfrom tip-over.Unplug this apparatus during lightning storms or whenunused for long periods of time.Refer all servicing to qualified service personnel.Servicing is required when the apparatus has beendamaged in any way, such as power-supply cord orplug is damaged, liquid has been spilled or objectshave fallen into the apparatus, the apparatus has beenexposed to rain or moisture, does not operatenormally, or has been dropped.13.14.Note to the CATV system installer:This reminder is provided to call the CATV systeminstaller’s attention to Article 820-40 of the NEC thatprovides guidelines for proper grounding and, inparticular, specifies that the cable ground shall beconnected to the grounding system of the building, asclose to the point of cable entry as practical.Example of antenna grounding as per NEC -National Electric CodeANTENNA LEAD IN WIREGROUND CLAMPANTENNA DISCHARGE UNIT(NEC SECTION 810-20)ELECTRIC SERVICE EQUIPMENTGROUNDING CONDUCTORS(NEC SECTION 810-21)POWER SERVICE GROUNDINGELECTRODE SYSTEM (NEC ART 250,PART H)GROUND CLAMPS1.2.3.4.5.6.7.8.9.10.11.12.Wall mount bracket kitBrand Model # Screw dimensionFW32D08F SANUS AST16 M4 x 1.378” (35mm)with spacer● Your TV meets the VESA standard for wall mounting. Consult withyour local dealer for a wall mount bracket which is compatible withyour TV model.● The recommended wall mount bracket kit (sold separately) allows themounting of the TV on the wall.● For detailed information on installing the wall mount, refer to the wallmount Instruction book.● Funai Corporation is not responsible for any damage to the productor injury to yourself or others if you elect to install the TV wall mountbracket or mount the TV onto the bracket on your own.● The wall mount bracket must be installed by experts.Funai Corporation is not liable for these types of accidents orinjuries noted below.● Install the wall mount bracket on a sturdy vertical wall.● If installed onto a ceiling or slanted wall, the TV and wall mount bracketmay fall which could result in a severe injury.● Do not use screws that are longer or shorter than their specified length.If screws too long are used this may cause mechanical or electricaldamage inside the TV set. If screws too short are used this may causethe TV set to fall.● Do not fasten the screws by excessive force. This may damage theproduct or cause the product to fall, leading to an injury.● For safety reasons use 2 people to mount the TV onto a wall mountingbracket.● Do not mount the TV onto the wall mounting bracket while your TVis plugged in or turned on. It may result in an electrical shock injury.When installing the unit on the wall, allow this much space.Top : 11.8 inches (30cm)Left and right side : 5.9 inches (15cm)Bottom : 3.9 inches (10cm)4 .English