395 123410 9 67815 14 13 1112VGA IN (D-SUB) TERMINALTerminal : D-SUB15 PINConnect video output terminal of LCD TV to this terminal with VGA Cable (not supplied). When connectingMacintosh computer, the MAC Adapter (not supplied) is required.Pin Configuration Red InputGround (Horiz.sync.)Green InputSense 2Blue InputGround (Red)Ground (Green)Ground (Blue)15243678No ConnectHoriz. sync.Ground (Vert.sync.)Sense 1Sense 0Vert. sync.Reserved9131012111415This LCD TV can correspond to the signals below. After connecting with the computer, LCD TV can auto-matically recognize the signal from the connected PC( computer)/ HDMI.PC SIGNAL MODE COLUMN (recommended)Note:● In case LCD TV can not display properly due to the connecting cable or the graphic hardware,please make adjustments about phase, clock and so on.● In principle, LCD TV can not display the signal mode which not described in the above column.But sometimes it can display a signal very similar with one of the signal described.● If you want to change the definition and colour of PC, please select one from the column.● It is not the trouble of LCD TV if interference appears on the picture while switching the signal mode.● It is different from CRT Monitor that it is no blink of the picture when the V-Freq. of the signal s 60Hz.It is recommended to select 60Hz V-Freq. of your computer to display better pictures.● The Dot Clock of the computer's signal must be less than 100 MHz.● Specifications are subject to change without notice.In case of the following things, some messages will display on the screen.● When the input signal from PC is out of the display range, "OUT OF RANGE" will display.ON1DIPONOFF2 3 4 5 6Set slide switches as shown in the table below depending on RESOLUTION MODE that youwant to use before you turn on LCD TV and computer.Slide Switches (1-6)CONFIGURATIONS OF VGA TERMINALSMAC ADAPTER (Not Supplied)SIGNAL MODE COLUMN (Recommended)ON ON OFFOFFOFFOFFOFFOFFOFFOFFOFFOFF1 2 3 4 5 619" Mode (1024x768)16" Mode (832x624)13" Mode (640x480)OFFOFF ONONONONAPPENDIX