Sanyo PLC-EF12B Owner's Manual

Also see for PLC-EF12B: Service manual

Contents

4COMPLIANCESFederal Communication Commission NoticeThis equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference whenthe equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radiofrequency energy and, if not installed and used in accordance with the instruction manual, may cause harmfulinterference to radio communications. Operation of this equipment in a residential area is likely to cause harmfulinterference in which case the user will be required to correct the interference at his own expense.AC Power Cord for the United Kingdom :This cord is already fitted with a moulded plug incorporating a fuse, the value of which is indicated on the pinface of the plug. Should the fuse need to be replaced, an ASTA approved BS 1362 fuse must be used of thesame rating, marked thus . If the fuse cover is detachable, never use the plug with the cover omitted. If areplacement fuse cover is required, ensure it is of the same colour as that visible on the pin face of the plug(i.e. red or orange). Fuse covers are available from the Parts Department indicated in your User Instructions.If the plug supplied is not suitable for your socket outlet, it should be cut off and destroyed.The end of the flexible cord should be suitably prepared and the correct plug fitted. (See Over)WARNING : A PLUG WITH BARED FLEXIBLE CORD IS HAZARDOUS IF ENGAGED IN A LIVE SOCKETOUTLET.The Wires in this mains lead are coloured in accordance with the following code:Green-and-yellow ············ EarthBlue ································· NeutralBrown ······························ LiveAs the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markingsidentifying the terminals in your plug proceed as follows:The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is markedby the letter E or by the safety earth symbol or coloured green or green-and-yellow.The wire which is coloured blue must be connected to the terminal which is marked with the letter N orcoloured black.The wire which is coloured brown must be connected to the terminal which is marked with the letter L orcoloured red.WARNING : THIS APPARATUS MUST BE EARTHED.ASAThe AC Power Cord supplied with this projector meets the requirement for use in the country you purchased it.AC Power Cord for the United States and Canada :AC Power Cord used in the United States and Canada is listed by the UnderwritersLaboratories (UL) and certified by the Canadian Standard Association (CSA).AC Power Cord has a grounding-type AC line plug. This is a safety feature to be surethat the plug will fit into the power outlet. Do not try to defeat this safety feature.Should you be unable to insert the plug into the outlet, contact your electrician. GROUNDTHE SOCKET-OUTLET SHOULD BE INSTALLED NEAR THE EQUIPMENT AND EASILY ACCESSIBLE.AC POWER CORD REQUIREMENT