Sanyo PLC-EF12B Owner's Manual

Also see for PLC-EF12B: Service manual

Contents

41COMPUTER MODEThe normal picture level is preset on this projector at thefactory and can be restored anytime you press the NORMALbutton (located on the Top Control or on the Remote ControlUnit). The “Normal” display will be displayed on the screen fora few seconds.NORMAL FUNCTIONNormalThe Auto Image adjustment is provided to automatically adjust Fine sync., Total dots, and Picture Position formost computers.Press the MENU button and the ON-SCREEN MENU willappear. Press the POINT LEFT/RIGHT buttons to select AUTOIMAGE and press the SELECT (REAR CLICK) button.Another dialog box AUTO IMAGE Menu will appear.Move the arrow to an item that you want to adjust by pressingthe POINT UP/DOWN button. Change the setting On or Off bypressing the SELECT (REAR CLICK) button.12Move the arrow to “Go!” and press the SELECT (REAR CLICK)button to start the Auto Image adjustment.This adjustment can be executed by pressing AUTO IMAGEbutton on the Projector or on the Remote Control Unit.3NOTE : This menu cannot be operated when the incoming signal is digital or “RGB,” “HDTV720p,” “HDTV1035i” or“HDTV1080i” is selected on the SYSTEM MENU (P36 and 37).The Fine sync., Total dots, and Picture Position of some computers may not be fully adjusted with the Auto ImageAdjustment. In that case, manual adjustment is required to make fine image. (Refer to page 40 to adjust "Finesync." or "Total dots" and page 42 to adjust Picture Position.)Terminates the PICTUREIMAGE ADJUSTMENT Menu.Move the arrow to theitem and then pressthe SELECT (REARCLICK) button.Starts the adjustmenton the item set to "On".Adjust the picture as necessary to eliminate flicker from the display.This item can be adjusted manually. (Refer to page 40.)The number of the total dots in one horizontal period. This item canbe adjusted manually. (Refer to page 40.)Adjustment of the position of the image. This item can be adjustedmanually. (Refer to page 42.)Fine syncTotal dotsPositionStores the On/Off setting of each item.StoredStarts the Auto Image Adjustment.Go!Closes the AUTO IMAGE ADJUSTMENT Menu.QuitAUTO IMAGE ADJUSTMENT