Sanyo PLC-WXU3ST Owner's Manual

Contents

Sanyo PLC-WXU3ST Owner's Manual Manual pdf 13 page image

13Part Names and FunctionsTo insure safe operation, please observe the following precautions:● Use two (2) AA or LR6 type alkaline batteries.● Always replace batteries in sets.● Do not use a new battery with a used battery.● Avoid contact with water or liquid.● Do not expose the remote control to moisture or heat.● Do not drop the remote control.● If the battery has leaked on the remote control, carefully wipe the case clean and installnew batteries.● Risk of explosion if a battery is replaced by an incorrect type.● Dispose of used batteries according to the instructions.Open the batterycompartment lid.Install new batteriesinto the compartment.Replace thecompartment lid.Two AA size batteriesFor correct polarity(+ and –), be surebattery terminals are incontact with pins in thecompartment.Remote Control Battery Installation1 2 3Point the remote control toward theprojector (Infrared Remote Receiver)when pressing any button. Maximumoperating range for the remote controlis about 16.4' (5 m) and 60° in front ofthe projector.Operating Range 16.4'(5 m)30° Remote control30°