Sanyo PLC-XK2600 Owner's Manual

Also see for PLC-WK2500: Manual Manual Manual Specification sheet Service manual

Sanyo PLC-XK2600 Owner's Manual Manual pdf 17 page image

17Connecting the AC Power CordThis projector uses nominal input voltages of 100-40 VAC and it automatically selects the correct input voltage.It is designed to work with single-phase power systemshaving a grounded neutral conductor. To reduce the riskof electrical shock, do not plug into any other type ofpower system.If you are not sure of the type of power being supplied,consult your authorized dealer or service center.Connect the projector with all peripheral equipmentbefore turning the projector on.Note:Unplug the AC power cord when theprojector is not in use. When this projectoris connected to an outlet with the AC powercord, it is in Stand-by mode and consumesa little electric power.To the AC outlet.(200 - 240 V AC)To power cordconnector on yourprojector.Projector side AC outlet sideTo the AC outlet.(120 V AC)For the U.S.A. and CanadaTo the AC outlet.(200 - 240 V AC)For Continental EuropeGroundFor the U.K.NOTE ON THE POWER CORDAC power cord must meet requirement of the country where you use the projector.Confirm the AC plug type with the chart below and proper AC power cord must be used.If supplied AC power cord does not match your AC outlet, contact your sales dealer.GroundThe AC outlet must be near this equipmentand must be easily accessible.CAUTIONInstallationConnect the AC power cord(supplied) to the projector.