Sanyo PLC-XK2600 Owner's Manual

Also see for PLC-WK2500: Manual Manual Manual Specification sheet Service manual

Sanyo PLC-XK2600 Owner's Manual Manual pdf 4 page image

4To the OwnerCAUTION:TO REDUCE THE RISK OF ELECTRIC SHOCK,DO NOT REMOVE COVER (OR BACK). NOUSER-SERVICEABLE PARTS INSIDE EXCEPTLAMP REPLACEMENT. REFER SERVICING TOQUALIFIED SERVICE PERSONNEL.THIS SYMBOL INDICATES THATDANGEROUS VOLTAGE CONSTITUTING ARISK OF ELECTRIC SHOCK IS PRESENTWITHIN THIS UNIT.THIS SYMBOL INDICATES THAT THEREARE IMPORTANT OPERATING ANDMAINTENANCE INSTRUCTIONS IN THEOWNER'S MANUAL WITH THIS UNIT.CAUTIONRISK OF ELECTRIC SHOCKDO NOT OPENBefore installing and operating this projector, read thismanual thoroughly.This projector provides many convenient features andfunctions.Operating the projector properly enables you to managethose features and maintains it in good conditionfor many years to come. Improper operation mayresult in not only shortening the product-life, but alsomalfunctions, fire hazard, or other accidents.If your projector seems to operate improperly, read thismanual again, check operations and cable connectionsand try the solutions in the “Troubleshooting” section onpages 63-65 of this manual. If the problem still persists,contact the dealer where you purchased the projector orthe service center.Safety PrecautionCAUTIONDO NOT SET THE PROjECTOR IN GREASY, WET,OR SMOKY CONDITIONS SUCH AS IN A KITCHENTO PREVENT A BREAKDOWN OR A DISASTER. IFTHE PROjECTOR COMES IN CONTACT WITH OIL ORCHEMICALS, IT MAY BECOME DETERIORATED.READ AND KEEP THIS OWNER'S MANUAL FORLATER USE.WARNING: THIS APPARATUS MUST BE EARTHED. TO REDUCE THE RISK OF FIRE ORELECTRIC SHOCK, DO NOT EXPOSETHIS APPLIANCE TO RAIN OR MOISTURE.– This projector produces intense light from the projectionlens. Do not stare directly into the lens, otherwise eyedamage could result. Be especially careful that childrendo not stare directly into the beam.– Install the projector in a proper position. Improperpositioning may reduce the lamp life and result insevere accident or fire hazard.– Allowing the proper amount of space on the top, sides,and rear of the projector cabinet is critical for properair circulation and cooling of the unit. The dimensionshown here indicate the minimum space required.If the projector is to be built into a compartment orsimilarly enclosed, these minimum distances must bemaintained.– Do not cover the ventilation slot on the projector. Heatbuild-up can reduce the service life of your projector,and can also be dangerous.– If the projector is unused for an extended time, unplugthe projector from the power outlet.– Do not project the same image for a long time. Theafterimage may remain on the LCD panels by thecharacteristic of panel.SIDE and TOP REAR0.7’(20cm)1.5’(50cm) 3’(1m) 3’(1m)20cm50cm 1m 1mFOR EU USERSThe symbol mark and recycling systems describedbelow apply to EU countries and do not apply tocountries in other areas of the world.Your product is designed and manufactured withhigh quality materials and components which can berecycled and/or reused.The symbol mark means that electrical and electronicequipment, batteries and accumulators, at their end-of-life, should be disposed of separately from yourhousehold waste.Note:If a chemical symbol is printed beneath the symbolmark, this chemical symbol means that the batteryor accumulator contains a heavy metal at a certainconcentration. This will be indicated as follows: Hg:mercury, Cd: cadmium, Pb: leadIn the European Union there are separate collectionsystems for used electrical and electronic equipment,batteries and accumulators.Please, dispose of them correctly at your localcommunity waste collection/recycling centre.Please, help us to conserve the environmentwe live in!CAUTIONNOT FOR USE IN A COMPUTER ROOM AS DEFINEDIN THE STANDARD FOR THE PROTECTION OFELECTRONIC COMPUTER/DATA PROCESSINGEQUIPMENT, ANSI/NFPA 75.