Sanyo PLC-XM100 Owner's Manual

Also see for PLC-XM100: Specification sheet Specifications Specifications Network manual Manual

Contents

11ᶉ R/C JACKWhen using the wired remote control, connect the wired remotecontrol to this jack with a remote control cable (not supplied)(p.15).ᶑ USB CONNECTOR (Series B)Use this connector when controlling a computerwith the remote control of the projector. Connectthe USB terminal of your computer to thisconnector with the supplied USB cable (p.19).ᶐ AUDIO 2 JACKConnect the audio output (stereo) signal from acomputer or video equipment (p.21).ᶍ VIDEO INPUT JACKConnect the component or the composite videooutput signal from video equipment to thesejacks (p.20).ᶅ CONTROL PORT CONNECTORWhen controlling the projector with RS-232C, connect thecontrol equipment to this connector with the serial control cable.(p.19)ᶊ COMPUTER INPUT TERMINAL (DIGITAL)Connect the computer output digital signal to this terminal. TheHDTV (HDCP compatible) signal can also be connected (pp.19-20).ᶇ COMPUTER INPUT TERMINAL (ANALOG)Connect the computer (or RGB scart) output signal to thisterminal (pp.19-20).ᶋ 5 BNC INPUT JACKSConnect the component or composite video output signal fromvideo equipment to VIDEO/Y, Pb/Cb, and Pr/Cr jacks or connectthe computer output signal (5 BNC Type [Green, Blue, Red,Horiz. Sync, and Vert. Sync.]) to G, B, R, H/V, and V jacks(pp.19-21).ᶅPart Names and Functionsᶌ S-VIDEO INPUT JACKConnect the S-VIDEO output signal from videoequipment to this jack (p.20).ᶏ AUDIO 1 JACKConnect the audio output (stereo) signal from acomputer or video equipment (p.21).ᶆ ᶇ ᶊᶍ ᶏ ᶈ AUDIO OUTPUT JACKThis jack outputs the audio signal from computer or videoequipment to external audio equipment (p.21). Kensington Security SlotThis slot is for a Kensington lock used to detertheft of the projector.*Kensington is a registered trademark of ACCOBrands Corporation.ᶃ INFRARED REMOTE RECEIVER (Back)The infrared remote receiver is also located in the front and top(pp.10, 15).ᶆ ANALOG OUT TERMINALThis terminal can be used to output the incoming analog RGBsignal from INPUT 1-3 terminal to the other monitor (pp.19-20).ᶈ ᶉᶐᶎᶋᶄᶑᶄ LAN CONNECTION TERMINALConnect the LAN cable (refer to the owner’s manual of “NetworkSet-up and Operation”).ᶃᶌᶎ AUDIO 3 JACKS (L(MONO)/R)Connect the audio output signal from videoequipment connected to ᶌ or ᶍ to this jack.For a mono audio signal (a single audio jack),connect it to the L (MONO) jack (p.21).Rear Terminal