Sanyo PLC-XM100 Owner's Manual

Also see for PLC-XM100: Specification sheet Specifications Specifications Network manual Manual

Contents

37Auto PC Adjustment function is provided to automatically adjust Fine sync, Total dots, Position H and Position V positions toconform to your computer.To store the adjusted parameters.The adjusted parameters from the Auto PC Adjustment can bestored in the projector. Once the parameters are stored, the settingcan be done just by selecting Mode in PC SYSTEM Menu (p.36).See “Manual PC Adjustment” on pages 38-39.Note:• Fine sync, Total dots, Position H and Position V position of certaincomputers cannot be fully adjusted with the Auto PC Adjustmentfunction. When the image is not provided properly with this operation,manual adjustments are required. (pp.38-39)• Auto PC Adjustment cannot be operated in Digital Signal Input on theDVI terminal and 480p, 575p, 480i, 575i, 720p, 1035i, 1080i or 1080p isselected on the PC SYSTEM Menu.• Depending on the condition of signals and the type and length ofcables, the signals may not be properly viewed.The Auto PC adjustment function can be operated directly bypressing the AUTO PC button on the remote control.AUTO PC buttonRemote ControlComputer InputPC adjust MenuPress the MENU button to display the On-Screen Menu. Usethe Point Ÿź buttons to select PC adjust and then pressthe Point Ź or the SELECT button.12 Use the Point Ÿź buttons to select Auto PC adj. and thenpress the SELECT button.Auto PC adj.Fine syncTotal dots 1366Position H 0Position V 0Current modeClamp 0Display area H 1024Display area V 768ResetMode freeStore0Auto PC adj.Fine syncTotal dots 1366Position H 0Position V 0Current modeClamp 0Display area H 1024Display area V 768ResetMode freeStore0Use the Point Ÿź buttons to select Auto PCadj. and press the SELECT button.Please wait... appears while the Auto PCadjustment is in process.Auto PC AdjustmentDirect OperationMenu OperationAuto PC adj.