Sanyo PLC-XU305A Owner's Manual

Contents

SettingNote:• Auto Keystone corrects vertical distortion only, notcorrect horizontal distortion.• The Auto Keystone function cannot work when theCeiling feature is set On in the Setting menu (p.52).• Perfect correction of the image distortion cannotbe ensured with the Auto setup function. If thedistortion is not corrected properly by pressing theAUTO SETUP/CANCEL button, adjust manuallyby pressing the KEYSTONE button on the remotecontrol or selecting Keystone in the Setting menu(pp.25, 48).• Fine sync, Total dots, Horizontal and Verticalposition of some computers cannot be fully adjustedwith the Auto PC Adjustment function. When theimage is not provided properly with this operation,manual adjustments are required (pp.33-34.Auto setupInput searchThis function detects the input signal automatically. Whena signal is found, the search will stop. Use the Point ▲▼buttons to select one of the following options.Off ......Input search will not work.On1 ....Input search works under the following situation.– When pressing the AUTO SETUP/CANCELbutton on the top control.– When pressing the AUTO SET/CANCEL buttonon the remote control.On ....Input search works under the following situation.– When turning on the projector by pressing theON/STAND-BY button on the top control or theremote control.– When pressing the AUTO SET/CANCEL buttonon the remote control.– When pressing the AUTO SETUP/CANCELbutton on the top control.– When the current input signal is cut off.** If the No show or Freeze function is active, cancel it toactivate the Input search. It is also unavailable when On-Screen menu is displayed.Auto PC adj.On . . . . . . Enables Auto PC Adjustment when pressingthe AUTO SET/CANCEL button on theremote control or the AUTO SETUP/CANCELbutton on the top control.Off . . . . . . Disables Auto PC Adjustment.Auto KeystoneAuto . . . . Always works and corrects keystonedistortion according to the projector's tilt.Manual . . Works only when pressing the AUTO SETUP/CANCEL button on the top control.Off . . . . . . Disables Auto Keystone.Auto setupNote:•While Input search is set to On1 or On, the status ofInput and Lamp are displayed every time the signal isswitched.•Only the last selected input source can be detected.•If the INPUT button on the top control or COMPUTER,VIDEO or NETWORK button on the remote control ispressed during Input search is in progress, Input searchwill stop and go back to the previous input signal.• Input search, Auto PC adj. and Auto Keystone cannot beset Off at the same time.This function enables Input search, Auto Keystone correctionand Auto PC adjustment by pressing the AUTO SETUP/CANCEL button on the top control. Settings for those functionscan be altered as follows: