PLC-XU305/355 Expand Serial Command Functional Specifications10/685. Functional Execution Command Table5.1 Image Command TableExecute command ItemCF_BRIGHT_%1[CR] Set Brightness valueCF_CONT_%1[CR] Set Contrast valueCF_COLOR_%1[CR] Set Color valueCF_TINT_%1[CR] Set Tint valueCF_SHARP_%1[CR] Set Sharpness valueCF_GAMMA_%1[CR] Set Gamma valueCF_WBAL-R_%1[CR] Set White Balance Red valueCF_WBAL-G_%1[CR] Set White Balance Green valueCF_WBAL-B_%1[CR] Set White Balance Blue valueCF_COLTEMP_%1[CR] Set Color Temp. valueCF_PROGV_%1[CR] Set /Cancel Progressive ScanCF_NZRED_%1[CR] Set/Cancel Noise reductionCF_IMAGE_%1[CR] Set Image modeCF_IMAGEADJ_%1[CR] Reset/Store for Image Adjustment5.2 PC Adjust Control Command TableExecute command ItemCF_FSYNC_%1[CR] Set Fine Sync valueCF_TDOTS_%1[CR] Set Total Dots valueCF_CLAMP_%1[CR] Set Clamp ValueCF_H-POS_%1[CR] Set Horizontal Position valueCF_V-POS_%1[CR] Set Vertical Position valueCF_DDOTS_%1[CR] Set Display Dots valueCF_DLINE_%1[CR] Set Display Line valueCF_PCSTORE_%1[CR] Store current values of PC Adjust at Mode 1-5CF_PCMODEFREE_%1[CR] Relese registered values of Mode1-5.5.3 Input Control Command TableExecute command ItemCF_INPUT_%1[CR] Select InputCF_SOURCE_%1[CR] Select Input SourceCF_INPUT1 _%1[CR] Select computer-1 and set Input selected in %1CF_INPUT2_%1[CR] Select computer-2 and set Input selected in %1CF_INPUT3_%1[CR] Select Video and set Input selected in %1CF_INPUT4_%1[CR] Select S-video and set Input selected in %1CF_INPUT5_%1[CR] Select Network and set Input selected in %1CF_INPUT_%1_%2[CR] Select Input and SourceCF_SYSTEM_%1[CR] Select System5.4 Screen Command TableExecute command ItemCF_SCREEN_%1[CR] Select Screen sizeCF_DZCENT_%1[CR] Cancel Digital Zoom modeCF_KEYSTONE_%1[CR] Set KeystoneCF_KYSTNMODE_%1[CR] Set Keystone Store modeCF_VSCALE_%1[CR] Set value of Vertical scaleCF_VPOS_%1[CR] Set value of Vertical positionCF_HSCALE_%1[CR] Set value of Horizontal scaleCF_HPOS_%1[CR] Set value of Horizontal position