Sanyo PLC-XU355A - 3500 Manual

Also see for 3000 ANSI LUMENS PLC-XU305: Brochure Specifications Specifications Datasheet Owner's manual

Contents

PLC-XU305/355 Expand Serial Command Functional Specifications37/688.10.14 CF_P-MANETIME CommandCommand “CF_P-MANETIME_%1”[CR]“01” ~ ”30” ----------------------- Directly select setting time by the minute“UP” ------------------------------- Plus one minute (01 → 02 → → 30 → 01)“DN” ------------------------------- Minus one minute(30 → 29 → → 01 → 30)DetailsSet Power Management timeThe status set by this command is stored in EEPROM and its setting is effectiveafter ALL is OFFThis command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]8.10.15 CF_ON-STA CommandCommand “CF_ON STA_%1”[CR]%1“ON” --------------------------- Set Power On Start to ON“OFF” ------------------------- Set Power On Start to OFF“UP” --------------------------- Switch setting (On → Off → On → )“DN” --------------------------- Switch setting (On → Off → On → )Note) “UP” and “DN” behave the same.DetailsSet/Cancel Power ON StartThe status set by this command is stored in EEPROM and its setting is effectiveafter ALL is OFFThis command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]8.10.16 CF_STANDBYMODE CommandCommand “CF_STANDBYMODE_%1”[CR]%1 “ECO” ---------------------- Less standby electricity“NORMAL” ------- -------- Normal standby electricityDetails Switch Standby Mode setting.This command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]8.10.17 CF_CCAPTIONDISP CommandCommand “CF_CCAPTIONDISP_%1”[CR]%1“OFF” ------------- Select Off“CC1” ------------- Select CC1“CC2” ------------- Select CC2“CC3” ------------- Select CC3“CC4” ------------- Select CC4DetailsSelect channel of Closed caption.The status set with this command is stored in EEPROM and its setting is effectiveeven after ALL is OFF.This command is available in normal Power ON status.Closed caption is available under conditions below;Entered signal is appropriate (Video, NTSC signal of S-video, Component=480i)and System is fixed to NTSC or 480i.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]