Sanyo PLC-XU355A - 3500 Manual

Also see for 3000 ANSI LUMENS PLC-XU305: Brochure Specifications Specifications Datasheet Owner's manual

Contents

PLC-XU305/355 Expand Serial Command Functional Specifications18/688.4.5 CF_SHARP CommandCommand “CF_SHARP_%1”[CR]%1“000~015” ---------------- Directly select Sharpness setting value“UP” ------------------------ Current Sharpness setting value + 1“DN” ------------------------ Current Sharpness setting value - 1DetailsSet Sharpness value of user controlThe value set by this command will not be saved to projector. Therefore, whenturning into Stanby-mode or ALL is OFF, the value returns to original setting. (Thevalue is held in Suspend mode.)This command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]8.4.6 CF_GAMMA CommandCommand “CF_GAMMA_%1”[CR]%1“000~015” ---------------- Directly set Gamma setting value“UP” ------------------------ Current Gamma setting value + 1“DN” ------------------------ Current Gamma setting value – 1DetailsSet Gamma value of user controlThe value set by this command will not be saved to projector. Therefore, whenturning into Stanby-mode or ALL is OFF, the value returns to original setting. (Thevalue is held in Suspend mode.)This command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]8.4.7 CF_WBAL - CommandCommand “CF_WBAL-%1_%2”[CR]%1“ ” --------------------- Red“ ” --------------------- Green“ ” --------------------- Blue%2“000~063” ----------- Directly select Color value specified by White Balance%1“UP” ------------------- Current Color value set by White Balance%1 + 1“DN” ------------------- Current Color value set by White Balance%1 - 1DetailsSet Color value set by White Balance%1 of user controlThe value set by this command will not be saved to projector. Therefore, whenturning into Stanby-mode or ALL is OFF, the value returns to original setting. (Thevalue is held in Suspend mode.)This command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]