Sanyo PLV-HD10 Owner's Manual

38SETTINGLamp counter resetKey lockFactory defaultPress POINT UP/DOWN button to move a red frame pointer to“Factory default” and then press SELECT button. The message"Return to Factory default?" is displayed. Move the pointer to [Yes]and then press SELECT button.Another confirmation dialog box appears and select [Yes] and thenpress SELECT button. Return the projector to Factory default.This function returns all setting values except for the lamp counter tothe factory default settings.This function locks the operation of the projector's control panel andthe remote control.This locks operation of the projector's control panel.This locks operation of the remote control.This cancels the Key lock function.If the projector's control panel accidentally becomes locked and youdo not have the remote control nearby, turn the MAIN ON/OFFswitch to OFF. And then while pressing a SELECT button, return theMAIN ON/OFF switch to ON again. This will cancel the projector'scontrol panel lock.Be sure to reset Lamp Counter when Lamp Assembly is replaced. When Lamp Replace Counter is reset, LAMPREPLACE indicator stops lighting.Turn projector on, press MENU button and ON-SCREENMENU will appear. Press POINT LEFT/RIGHT button(s) tomove a red frame pointer to SETTING Menu icon.1Press POINT DOWN button to move a red frame pointer to“Lamp counter reset” and then press SELECT button.2Do not reset Lamp Replace Counter except after Projection lamp isreplaced.Another confirmation dialog box appears and select [Yes] toreset Lamp Replace Counter.4Move arrow to replaced lamp number (Lamp 1, Lamp 2, Lamp 3or Lamp 4) and then press SELECT button. Message "Lampreplace counter Reset?" is displayed. Move pointer to [Yes] andthen press SELECT button.3NOTE: Be sure to reset correct lamp number otherwise LAMPREPLACE indicator continues lighting.Closes SETTING MENU.Quit