Remote Control CodeNumber of Times ofPressing IMAGEButton19BEFORE OPERATIONTo insure safe operation, please observe following precautions : Use (2) AA, UM3 or R06 type alkaline batteries. Replace two batteries at same time. Do not use a new battery with an used battery. Avoid contact with water or liquid. Do not expose Remote Control Unit to moisture, or heat. Do not drop Remote Control Unit. If a battery has leaked on Remote Control Unit, carefully wipe case clean and install new batteries. Danger of explosion if battery is incorrectly replaced. Dispose of used batteries according to the batteries manufacturers instructions and local rules.Press lid down-ward and slide it.Remove batterycompartment lid.Slide batteries intocompartment. Replace compartment lid.Two AA size batteriesFor correct polarity (+ and–), be sure batteryterminals are in contactwith pins in compartment.Remote Control Batteries Installation1 2 3Operating RangePoint Remote Control Unit towardprojector (Receiver Window)whenever pressing any button.Maximum operating range forRemote Control Unit is about 16.4’(5m) and 60° in front and rear of aprojector.16.4’(5 m)60°16.4’(5 m)60°Code ChangeThis projector has eight different remote control codes (Code 1-Code 8); thefactory-set, initial code (Code 1) and the other seven codes (Code 2 to Code 8).This switching function prevents remote control interference when operatingseveral projectors or video equipment at the same time. (Change the remotecontrol code for the projector first before changing that for the remote control. See“Remote control” on page 39.)While pressing the MENU button, press the IMAGE buttonnumber of times corresponding to each remote control codenumber. Each time you press the IMAGE button, the code ischanged sequentially. (See the list below.)1To initialize the remote control code for the remote control,slide the RESET switch to the RESET, and then to the ON.The initial code is Code 1.2RESETRESETFOCUSZOOMON-OFFSELECTCode 1 1Code 2 2Code 3 3Code 4 4Code 5 5Code 6 6Code 7 7Code 8 8MENU buttonIMAGE buttonRemote Control Code Change and Operating Range