Sanyo PLV-WF10 Service Manual

Also see for WF10 - PLV WXGA LCD Projector: Owner's manual Specifications

- 110 -7 Adjust focus of the Projection Lens. (LNS-W01, LNS-W01Z, LNS-T01, LNS-T01Z and LNS-W03only.) Set up the projector and project image on the screen. Loosen Focus Lens Lock Screw androtate Projection Lens to obtain proper focus. After adjusting focus, be sure to lock Projection Lenswith Focus Lens Lock Screw securely. (See Fig. 4.) Adjust focus of Projection Lens MODEL LNS-W03, following Focus Adjustment on page 6.8 Replace Upper Lens Cover. Fix Upper Lens Cover with 4 Screws C. (See Fig.2.)Except Model LNS-W01, LNS-W01Z, LNS-T01 and LNS-T01Z, proceed following below.Slide Light-Block Sheets into the guide of Upper Lens Cover and set them in front of the flap.(See Fig. 9.)9 Replace Lower Lens Cover. Fix Lower Lens Cover with 2 Screws A. (See Fig.1.)Except Model LNS-W01, LNS-W01Z, LNS-T01 and LNS-T01Z, proceed following below.Slide Light-Block Sheets into the guide of Lower Lens Cover and set them in front of the flap.(See Fig.9.)10 Turn the projector on and operate Lens shift, Zoom and Focus fully to check Light-Block Sheets.If Light-Block Sheets interfere with those operations, check Light-Block Sheets are set properly.Fig-9LOWER LENSCOVERLIGHT-BLOCKSHEETSSlide into frontof the flap.FLAPSlide both upper sides of LIGHT BLOCKSheets in between and .21GUIDE12UPPER LENSCOVERFLAP