18Connect the projector’s AC power cord into an AC outlet andturn the Main On/Off switch on. The POWER indicator lightsred.Press the POWER ON/STAND-BY button on the top control oron the remote control.The POWER indicator turns green and the cooling fans start tooperate. As the automatic slide shutter opens, a preparationdisplay appears on the screen and the countdown starts.2314 After the countdown, the input source that was selected thelast time appears on the screen.Turning On the ProjectorComplete peripheral connections (with a computer, VCR,etc.) before turning on the projector.Selected Input SourceOFF ONMain On/Off switch✔Note:• If the automatic slide shutter does not open properly, the projectorwill not be turned on and the POWER indicator will blink orange.Press the POWER ON/STAND-BY button again to restart.• When “Countdown off” or “Off” is selected in the Display function,the countdown will not be displayed on the screen (p.40).• During the countdown period, all operations are invalid.• Image may look dark for a while after turning on the projector.Lamp needs some time to stabilize after the power is turned on.Stored lamp mode and the image mode will be active after thelamp is stabilized.Top Control Remote ControlPOWER indicator POWERON/STAND-BybuttonAutomatic Slide ShutterDo not touch the slide shutter while it ismoving, as this could cause injury or theprojector to malfunction.Use this tab when handling manually.Basic OperationDownloaded From projector-manual.com Sanyo Manuals