Sanyo PLV-Z2000 Owner's Manual

Also see for PLV-Z2000: Owner's manual Service manual

Contents

45Cleaning the RGB panelsBlemishes such as dust and dirt on the internal optical components of the projector tend to degrade the brightness of thescreen and are likely to appear as a shadow on the screen, which can lead to deterioration of image quality.This projector has the RGB panel cleaning holes on the underside for cleaning of the internal parts (such as opticalcomponents) of the projector. When you use the projector for a lengthy period of time or a shadow of dust appears on theprojected screen, clean the inside of the projector.Using the supplied air blower and with the Cleaning function in the Setting Menu (p.42), you can remove the dusts from theprojector.CAUTION IN USING THE AIR BLOWER AND THE NOZZLE● Turn the projector over when using the blower.● Use only the supplied air blower and nozzle to keep the projector from being out of order ordamaged. We could not guarantee the malfunction or breakage caused by other tools.● Never use a commercially available compressed air duster. It causes the interior of the projector tomalfunction with release of cold liquid propellant.● Put the projector on a soft cloth to prevent scratching the surface.● Open the hole cover only when you clean the inside of the projector.● Do not look into the holes. A strong light could damage your eyes. (Do not look into the Air intakevent and Exhaust vent, too.)● Use the blower and nozzle only to clean the projector. Do not attempt to use them for otherpurposes. Do not use the blower and nozzle against persons (particularly to eyes, mouth, or ears).Be especially careful to ensure that children do not put the blower and nozzle into their mouth andswallow them.● Do not attempt to pull the nozzle out of the blower. If the nozzle happened to be pulled out, put itback into the blower immediately.● Do not use the blower supplied with this projector (model: Z2000) to clean the other models: Z3and Z1X.If something is wrong with the projector (such as smoke, a strange sound, or an abnormal odor) while you arecleaning, turn off and unplug the projector immediately, then call the dealer where you purchased the projector orservice center.✔Note:• Dust might not be removed completely with these steps. Then contact the dealer where you purchased the projector or servicecenter.If the nozzle is pulled outThe nozzle has the stopper. Put the stopper-side of the nozzle intothe blower. Put the nozzle firmly into the blower until the stopperbecomes invisible.When putting the nozzle into the blower, hold near the stopper sothat it will not break.Be sure not to try to pull the nozzle out of the blower.CAUTIONPROHIBITEDMaintenance and CleaningStopperHold near the stopperof the nozzle.Put the nozzle inuntil the stopperbecomes invisible.Put this end ofthe nozzle into theblower.Downloaded From projector-manual.com Sanyo Manuals