46 Installation TB9100 Installation and Operation Manual© Tait Electronics Limited May 20064. Read the base station’s configuration.5. Select “Configure > Digital Line > Network Identity”.6. Enter the subnet and the IP address specified for this base station bythe IP addressing plan for the network. Also enter a suitable name forthe base station.Important Be careful to enter the correct address and subnet, and tokeep a written record of them. If you give the base stationan unknown IP address or subnet, the CSS will be unableto connect to it.7. Click OK to confirm your entry and exit the configuration form.8. Click “Tools > Connections” and add an entry to the connectionslist, consisting of the name and IP address you have entered.9. Make any other configuration changes that are required, and clickSave to save them to file.10. On the toolbar, click Program to program the information into thebase station.11. Click Overwrite to confirm that you really do want to change theIP address.12. Reset the base station so that the new IP address and name take effect.This disconnects the CSS.13. Wait for the base station to power up, then on the toolbar, click theConnect icon.14. Select the entry you added to the connection list and click Connect.15. In the status bar, verify that you are actually connected to the basestationFinding a Lost or Forgotten IP AddressUse the following procedure if an IP address has been lost or forgotten.1. Connect your PC to the 9-pin serial connector on the back of thereciter.2. Run a program such as HyperTerminal, Teraterm or minicom.3. Select the following port settings: 57600 baud, 8 bits, no parity, 1 stopbit, no flow control.4. Press the ‘Enter’ key. A login prompt will appear displaying the basestation’s IP address.