TM8000 3DK Hardware Developer’s Kit Application Manual Programmable I/O Lines 75September 2003 © Tait Electronics Ltd3.2.10 Call Setup StatusThis output signal is activated when the radio is busy in a voice call.It remains active as long as the call is in progress, and may be used to triggeran application such as a voice recorder, or to quieten external audioequipment during the call.Configuration 1. Configure an output line and associate it with this action. Set theactive state to be high or low (as required).2. Configure the Monitor function to activate on both call receptionand call initiation. Set the Monitor Auto-Quiet timer to minimise thechance of turning the Monitor off in the middle of a call.Timing The call setup status signal will respond within 2ms of monitor activationduring call setup or reception.Description This output signal is activated when the monitor function is activated byeither a call setup or call reception.The signal will be deactivated when the call is finished i.e. when the monitoris deactivated again due to auto-quiet timeout or reset signalling.Note The monitor function does not get activated if the call is deter-mined to be non-voice e.g. contains a control status.Related Actions None.
