Feb 0534PPM Laser Printer User Guide 8-15Using the Hard Disk Option and User Flash DIMM ModuleCollating, Saved Jobs, and Job AccountingThe features discussed in this section are designed to work with the Hard Disk Option. However, ifno Hard Disk Option is installed, but a User Flash Option is installed, these features will utilize theUser Flash Option. If both the Hard Disk Option and a User Flash Option are installed, these fea-tures will default to the Hard Disk Option.There are two new features available using the Hard Disk or User Flash Option; Collating andSaved Jobs. The drivers that support these new features are as follows:• PCL – All windows platforms• PostScript – Windows 2000 and Windows XPCollating FeatureWhen this feature is enabled, multiple copies of the entire document (all pages e.g. 1-3, 1-3, 1-3)will be printed in sequential order rather than multiple copies of each individual page (111, 222,333).You access the collating feature through the drivers that support this feature. But, before these fea-tures can be used, either Flash or Disk must be set as installed in driver Device Settings. To accessthe Collating feature on your desktop, go to the Start menu, left click on Settings, left click onPrinters, and then click on your printer driver icon, right click and follow the menu to the Proper-ties menu.Use the following procedure to enable collating:1. Click on the Device Settings button. Scroll down and make sure a Hard Disk option or User Flash isinstalled. Then click the OK button. A Hard Disk or User Flash must be installed to use the CollatingFeature.