7265 Programmer’s Manual9Copyright © 2004 TallyGenicom Chapter 2 ANSIPrinter ControlCommands DescriptionSO SHIFT OUTYou can strap the printer to start either barcode (page 37) or oversized (page 64)mode, whichever is enabled, on receipt of SO. The ISU status of SO/SI control isdisabled. You can enable SO/SI control from Software Options on the printed menu,or from the host via the Straps and Options control sequence. See page 14.Dec 14 Hex 0ESI SHIFT INIf the printer is strapped to turn on barcode or oversized on receipt of SO, then SIturns barcode (page 37) or oversized (page 64) mode off.Dec 15 Hex 0FESC ESCAPEIntroduces an escape sequence. The printer evaluates characters following the ESCcharacter to determine if the sequence is valid. If the sequence is valid, then theprinter responds to the command. If the sequence is not valid, then the printer abortsthe process, discarding at least the first character following ESC.Dec 27 Hex 1BESC P(DCS)DEVICE CONTROL STRINGThe control function introducer for the device control string structure, which is used toframe graphics.Dec 144 Hex 90ESC [(CSI)The CSI character is the control function introducer for the ANSI control sequence.Control sequences are multi-character control functions that accept parameters.Dec 155 Hex 9BESC \(ST)STRING TERMINATORTerminates the DCS and the OSC sequence.Dec 156 Hex 9CESC ](OSC)The OSC character is the introducer for straps and options.Dec 157 Hex 9DBEL BEEPERDec 7 Hex 07