7265 Programmer’s Manual 10Copyright © 2004 TallyGenicom Chapter 2 ANSICommands DescriptionDEL DELETEDEL is a printable character, or is a valid graphics data byte if receivedin dot graphics mode.Dec 127 Hex 7FESC [(p1);(p2)>~SELECT EMULATIONIf p2 is 0, which is the default, then the current settings in the printer remain in effectthrough the emulation change to the extent that selected features are supported inthe target emulation. This affects such things as, font selection, character pitch,margins, tabs, and so forth. If p2 is 1, then the status of such parameters reverts todefaults dependent on the selected emulation.p1 selects0 GENICOM ANSI1 Tally ANSI2-21 Reserved22 Epson FX286ep2 selects0-1 full resetExample: Select Epson emulation with full reset:Dec 27 91 50 50 59 49 32 126 Hex 1B 5B 32 32 3B 31 20 7EESC [(p1)p SELECT PAPER PATHp1 selects08 unload current path10 unload current path and load tractor 212 unload current path and load tractor 1Forms in the current path should be torn off before changing paper paths. Ifyou send a command to change paper paths and there is more paperdownstream of the print head than 1/2 times the current form length or sixinches, whichever is greater, then the printer returns paper to the position thatwas current before the command was received, and a fault condition is set.If you send a command to change paper paths and the target path is thecurrent path, then the printer executes a form feed. If you load tractor 2Example: Unload tractor 1 and load tractor 2:Dec 27 91 49 48 112 Hex 1B 5B 31 30 70when tractor 2 is not installed, the command will be ignored.
