Tascam DM-24 Automation Manual

Also see for DM-24: User guide Basic guide Quick start guide Basic guide Installation information

4 – OperationTASCAM DM-24 Automation 21Write To End:When the Write Revert Time is set to ∞s, you areessentially telling the automation system to maintaina control’s last setting from the point where the auto-mation recording ends, all the way to the end of theprogram. This is called Write To End. In this case,any mix moves existing in the time between the endof automation recording and the end of the programwill be erased.NOTEA Write/Trim To End operation must be completed bystopping the time code. Manually disabling Write orTrim mode while time code is running will not performa Write To End operation.AUTO REVERT must be enabled to use Write To End.See the diagrams below to understand how thisworks:Figure 13 – Write To End over previous Static fader positionFigure 14 – Write To End over previous Dynamic fader moves.8 sec8 sec+12+6+30-3-6-12+12+6+30-3-6-121 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec-9Existing Static Fader PositionMix MoveTouch Fader Release Fader Stop Time CodeFaderMovement8 sec8 sec+12+6+30-3-6-12+12+6+30-3-6-121 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec-9Existing Fader MoveMix MoveTouch Fader Release Fader Stop Time CodeFaderMovement