Repeat32 TASCAM DP-01 Owner’s ManualAdvanced techniquesRepeatRepeat allows you to repeat the playback or auto-punched rehearsal (see“Rehearsal” on page 29) between the IN and OUT points.You can’t set thesepoints when theREPEAT key is lit.… First, set the IN and OUT points at the place where you want therepeat loop to start and stop (see “IN and OUT marks” on page 26).… Press the REPEAT key briefly so that the indicator lights. Playbackstarts automatically from the IN point.… When the playback reaches the OUT point, playback pauses for ashort while (see “Setting the repeat interval” on page 32) and the PLAYindicator flashes before playback starts again, and the PLAY indicatorlights steadily.… Turn off the repeat function by pressing REPEAT so that the indicatorgoes out.Repeat auto-punch rehearsal, but not repeat auto-punch recording, isalso possible. If AUTO PUNCH, RHSL and REPEAT are all lit, pressingRHSL to go from rehearsal to auto punch recording mode will alsoturn off REPEAT.Setting the repeat intervalYou can set the time between repeats up to 9.9 seconds.This repeat inter-val allows you toreposition your hands for a guitarlick, take a breath for a vocalphrase, etc. when you arerehearsing.… Press and hold the REPEAT key for about a second, and the screenshows:Use the wheel to set the repeat interval from 0.5 seconds to 9.9 sec-onds in 0.1 second steps.… Press REPEAT again briefly to exit the interval setting mode.A B S 0 0 : 0 2 : 3 4 : 2 1- - - - - - - - - - - - - - - -R E P E A TI N T E R V A L / 1 . 7