Tascam DP-01 Owner's Manual

Also see for DP-01: Owner's manual Specifications Quick start guide Quick start guide

Contents

Tascam DP-01 Owner's Manual Manual pdf 50 page image

About track editing50 TASCAM DP-01 Owner’s ManualAdvanced techniquesCLONE TRACKThis copies a track or pair of tracks to another track or pair of tracks. The IN andOUT points do not have any meaning here.… There are two values that you can change:Src. Trk Select an individual track (1 through 8), a pair of tracks (1/2, 3/4, 5/6,7/8) or the MASTER stereo track.Dst. Trk This sets the destination track or tracks to which the source track iscloned. What you can select here depends on what you have selected for thesource track. If you have selected a single track, you can select tracks 1 through8 here. If you have selected a pair of tracks (for instance, 1/2), you can onlyselect track pairs here.If you try to selectthe same track as adestination that you have se-lected as the source, when youpress the YES key, a message willappear.Press YES to perform the operation or NO to leave this screen.Although you cannot mix the inputs to the STEREO MIX to themixed master track, you can add a drum machine (say) to themix in the following way:• Mix down to the mix master track, using the EFFECT SEND and EFFECTRETURN (“Mixdown and mastering” on page 23) to add reverb to your mix.• Clone the stereo mix to a pair of tracks.• Disconnect the drum machine from the STEREO MIX and connect it to theRETURN jacks. Make sure that it is set up to be synchronized to the DP-01(“Working with MIDI” on page 35).• Mix down again with only the two cloned tracks, using the EFFECTRETURN control to add and adjust the level of the drum machine. You thenhave a mix including the drum machine as well as the effect added to themain tracks.CLEAN OUTThis deletes all the material in a track or tracks. The IN and OUT points do nothave any meaning here.… There is only one value that you can change:Src. Trk Select an individual track (1 through 8), a pair of tracks (1/2, 3/4, 5/6,7/8), or all the tracks (1-8).Press YES to perform the operation or NO to leave this screen.Undoing operationsIf you have made a mistake on the DP-01, very often you can undo it! Thisincludes the track editing operations described here, as well as most other com-mon operations you can perform (including recording).… Press the UNDO key briefly, to undo the last undoable action.orYou must haveperformed at leastone undoable action after switch-ing on for the undo function towork!… Press and hold the UNDO key for about a second, to show the UNDO/REDO screen:Figure 2.11: Cloning tracksFigure 2.12: Cleaning out atrack- U N D O / R E D O -C O P Y P A S T E ← 2/ R E C O R D I N G 1- S T A R T U P - 0