Tascam X-48MKII Owner's Manual

TASCAM X-48MKII 31on the track before recording over a section of thatperformance.ADR Monitoring ModeADR Monitoring Mode is similar to Auto Input, but putsthe track in input only when the transport is in record.The track reverts to playback in stop or play to preventfeedback.All Input modeAll Input mode enables input monitoring for all tracks,whether they are armed for recording or not. This mode isoften used for live recording.Input monitoring can be set the following ways.Mouse/Keyboard Operation• For Auto Input, click on the Options menu, scrollover the Auto Input submenu and select On or ADR.• For All Input, click on the Options menu and selectAll Input.Front Panel Operation• To enable Auto Input, press the AUTO INPUTbutton on the front panel.• For All Input mode, hold the SHIFT button whilepressing AUTO INPUT.Putting Individual Tracks into InputTIPWhen auto input is off, you can set the input mode forindividual tracks.You can put tracks into input mode on a channel-by-channel basis.1 From the Mouse/Keyboard interface, click the Ibutton next to any track number.2 From the front panel, hold the SHIFT button andpress any track arming button.Record EnableMouse/Keyboard Operation• Click on the R button to the right of the tracknumbers on the left side of the screen in the Tracksview. The button will flash red to indicate it is readyfor record.Front Panel Operation• Press the Record Enable buttons on the frontpanel. The Record indicator will flash on tracks thatare ready to record.Punch Crossfade TimeTo avoid an audio click when punching in and out ofrecord, the X-48MKII automatically fades into and out ofrecord. This crossfade time is very fast, but prevents anaudio pop. The crossfade time can be set between 0ms(disabled) and 90ms in increments of 10ms.Mouse/Keyboard Operation• Click on the Windows menu and select Settings. Selectthe Prefs tab and click the Punch Crossfades submenu.Select the desired crossfade time.Front Panel Operation• Press the PREF button and use the 5/b buttonsto select Punch Crossfade. Press the CHNGbutton, select the desired crossfade time using the5/b buttons and press CHNG again.Undo/RedoUnlike tape machines, you can undo a recording pass andthen put it back with redo. Undo/redo is only availablefrom the mouse/keyboard interface.Mouse/Keyboard Operation (only)• Click the Edit menu and choose Undo or pressControl-Z on the keyboard.• To redo an operation, click the Edit menu and selectRedo (or press Control-Y on the keyboard). You canalso use the History List to undo and redo. Fordetails, see “History List” on page 44.MeteringYou can change various settings for the GUI meters shownat the top of the screen on a connected display.TIPIf the GUI meters are not shown, click the meter buttonor press the keyboard “1” key to show them. (The numerickeypad “1” does not have this function.)Meter button5 – Recorder