Terex PT100 Forestry Service & Repair Manual

Also see for PT100 Forestry: Operation and maintenance manual

Contents

Terex PT100 Forestry Service & Repair Manual Manual pdf 43 page image

Compact Track Loader9. Transmission and Drive Disassembly and Assembly9-4Auxiliary Pump Installation1. To install auxiliary pump, reverse the removalprocedure.Tandem Pump RemovalThe tools required for tandem pump removal andinstallation are listed in Table 9-2. Use manufactur-er-recommended tools whenever possible.Table 9-2Required ToolsScrewdriverCombination WrenchSocket WrenchHose plugs and capsHot oil can cause personal injury. Make sure theoil is cool before removing any components or lines.Remove the oil filler cap only when the engine isstopped and has been allowed to cool thoroughly.Collect and contain liquids in a suitable contain-er. Dispose of all liquids according to local regula-tions and mandates.Note: During disassembly, cap all hoses and fittings toprevent fluid loss and contamination of the system fluids.1. Remove the charge pump and the auxiliarypump.2. Label and remove all the hoses and tubes fromthe tandem hydrostatic pump. Be sure to cap allhoses and fittings.Figure 9-113. Secure the pump by chain or floor jack to preventit from falling once mounting bolts are removed.Figure 9-124. Remove the mounting bolts (with spring lockwasher and flat washer) from either side of the tan-dem pump. You will need to slide the pump awayfrom the engine mounting plate as you loosen thebolts to prevent the bolt heads from bottoming outon the pump case. Then lift pump out. (fig. 9-12)RemoveBoltsSupport pump priorto removing bolts