Terex PT100 Forestry Service & Repair Manual

Also see for PT100 Forestry: Operation and maintenance manual

Contents

Terex PT100 Forestry Service & Repair Manual Manual pdf 56 page image

To replace worn rollers:1. With the machine turned off and parked in a safeworking area, follow steps 5-11 in the trackremoval procedure on page 11-8 to expose thesprocket for roller replacement.2. Remove the bolt (A) holding the steel pins (B) androllers (C) in place. The pins and rollers will thenfall free from the sprocket.3. Install the new rollers over the pins.4. Slide the bolt back through the sprocket and pinsand tighten.5. Repeat this procedure as necessary throughoutthe sprocket.6. Follow steps 10-14 in the track installation proce-dure on page 11-10 to re-install the drive table andprepare the machine for track tension adjustment.7. Repeat steps 1-6 of this procedure on the otherside of the machine if necessary.8. Perform the track tension adjustment procedure onpage 11-4 to complete the procedure.Note: Terex recommends replacing external rollers as a setto simplify inspection and maintain proper sprocket function.Note: Internal pins should be inspected when replacingrollers. Internal pins do not rotate during operation and mayexperience uneven wear. If when replacing external rollers,internal pins are worn on one side only and appear to be ingood condition otherwise, they may be rotated 180 degreesfrom their original position and reused. Replace if worn toless than 35% of original thickness.Tilt-Up CanopyThe ROPS/FOPS approved canopy tilts up to alloweasier access while performing service work. It fea-tures a gas spring assist and a brace mechanism tohold it in place while tilted.To raise the canopy:1. Remove any attachment fastened to the quickattach.2. Raise the lift arms and secure with lift arm brace.3. Remove the bolts at the base of the canopy thatfasten it to the chassis.4. Remove the air pre-cleaner assembly (1) from themachine.5. Remove the two limb risers (2) from the machine.6. Raise the canopy and watch to make sure thelock-out brace falls into place.7. Secure the canopy lock-out brace with the D-latchpin (3) as shown.The canopy is now secure.11-5Compact Track Loader11. MaintenanceCBA122Turn the engine off, remove the key from theignition and disconnect battery prior to per-forming this procedure.Canopy3