T+A SADV 1245 R User Manual
                                                      | |
Contents
|
36Back panel connections / MULTI CHANNEL ANALOG OUTThe analogue output of this player deliveres analoguemulti channel () and stereo- () output signals. Themulti channel output can be connected to surrounddecoders/receivers with a 5.1 or 7,1 multi channel input.The stereo output can be connected to any stereo pre-amp, integreted amp or receiver.Note:In a system the MCH output is connected to the 5.1or 7.1 MCH input of the surround decoder / surroundreceiver. (see wiring diagrams 1 and 2). WIDESwitch for the analogue high frequency output filter of theSADV 1245 R. With this switch the bandwidth selction(switch 'WIDE' on the front panel) can be disabled forsecurity reasons.Set this switch to the position 'disabled' if your amplifieror loudspeaker system is not capable of processing audiosignals above 100 kHz.Note:For all amplifiers the position 'WIDE ENABLE' canbe safely used. Attention!If you are not sure if your system is suited for widebandwidth operation, please consult the manual of theamplifier and speaker system.If in doubt, please use the position 'WIDE DISABLE'. DIGITAL OUT SURROUNDOptical digital output for connecting a digital surrounddecoder.Co-axial digital output for connecting a digital surrounddecoder. Please be sure to use high-quality 75 Ω cablewith Cinch connectors. RC-INInput socket for external IR (infra-red) remote controlreceiver E2000 (* optional accessory) or external remotedevice such as a programmable key pad. RLINKControl input / output sockets for the RLINK system:Both sockets are wired identically - either of the twosockets can serve as input, while the other can then beused as output to the next RLINK device. RLINK 2nd ADDR.Toggle switch for the selection of the remote controladdress of this device within a -RLINK system.Note:If no CD player is operated within the 'R' system,the 'RLINK 2nd ADDR.' switch of the SADV 1245 R shouldbe configured to the additonal CD address (positionswitch position = 'CD')In this case the stereo output should be connected tothe CD input of the pre- or integrated amplifier. The button will then select the SADV 1245 R fornormal stereo CD play back, the DVD button will selectthe SADV 1245 R for DVD play back. The unit willrespond to remote control signals for both of the CD andDVD inputs.If a stereo CD player is present in the system, please setthe switch to position '-'. The SADV 1245 R now will onlyrespond to remote control signals if the input DVD isselected as source. |
Related manuals for T+A SADV 1245 R
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine