Searching a Trunked BankIf programming a Type I system, you cannot Scan thetrunking bank you just programmed unless you enter talkgroups into memory. See ahead for details. With thesearch function, you’ll be able to find all the active talkgroups within the trunked system.Once the datachannel is acquired,the scanner beginstrunk tracking. Talkgroup ID’s, whichrepresent differentservice groups, beginto display.While searching, you won’t know exactly who the ID’s areassigned to unless you listen awhile or until ID lists areavailable in frequency guides or on internet sites. However,it usually only takes a few minutes to figure out police, fire,and emergency medical personnel. Other IDs may takesome time, but determining who each ID represents is halfthe fun of TrunkTracker™.Changing the Display ModeWhile monitoring a trunking bank in any of the trunkmodes, press to change the display mode. You candisplay one of the following conditions:n Current Scan Listn Current Active Banksn Repeater Activity IndicatorsYou will find more information on these channel activityindicators later in this section.42
