Enter SetupContinuous ModeThis mode enables the engine to scan/capture, decode and transmit over and over again.If the Continuous Mode is enabled, the engine activates/suspends/resumes barcode reading through control over thetrigger signal. When barcode reading is in progress, terminating the trigger signal after having kept it valid for 30ms orlonger will suspend barcode reading; when barcode reading is suspended, performing the same control over the triggersignal will resume barcode reading.Continuous ModeTimeout Between Decodes (Same Barcode)In order not to decode a barcode repeatedly, you can program this parameter to prevent the engine from rereading thesame barcode in a given period of time.This parameter sets the timeout between decodes for the same barcode in the Continuous Mode. It is programmable in 1msincrements from 1ms to 3600000ms. The default timeout is 1500ms.To learn how to program this parameter, see the “b. Program the Timeout between Decodes (Same Barcode)” sectionin Appendix.Timeout Between Decodes (Same Barcode)Disable Timeout Between Decodes: Allow the engine to re-read the same barcode.Enable Timeout Between Decodes: Do not allow the engine to re-read the same barcode before the Timeout BetweenDecodes (Same Barcode) occurs.19 **Exit Setup
