VECTOR 3 M A N U A LMAN‐004 REV 7.2 41 7/20/2017PLACING THE BAG IN THE CONTAINER (WITH NO STAGING LOOP OR SKYHOOK)1. Place the bagged canopy on the maincontainer and position the reserve risers in thereserve pack tray. Fan the links rather thanstacking them on each other, placing the rearlinks to the outside. Be sure to place the reserverisers far enough in the pack tray so they will lieflat over the shoulders.NOTE: The pre‐stretched reserve closing loopwill measure 4 ½” +/‐ ½”.2. Pass the pull‐up cord through the reserve bagas usual.3. Place the bagged canopy in the pack tray,taking extra care to fill the lower corners. Thenuse the pull‐up cord to pull the closing loop upthrough the bagged canopy. Secure it with atemporary locking pinCLOSING THE CONTAINERThe reserve flaps are numbered 1‐6 forreference. Close them in proper sequence.NOTEIf a T‐bar was passed through the bag,thread the ends of the pull‐up cordthrough the hole in the end of the T‐bar.Remove the T‐bar from the baggedcanopy, pulling the closing loop and pull‐up cord through it.
