VECTOR 3 M A N U A LMAN‐004 REV 7.2 73 7/20/2017ASSEMBLYBefore assembling the Booth 3‐Ring release system, make sure the risers aren’t twisted or reversed. Lay the Vector 3face down, as you would to pack it.1. Thread each cutaway cable into its housing and fasten the handle to the harness. The handle should be positionedas close to the ends of the housings as possible so that little or no cable is exposed.2. With the rings of the riser facing toward thefloor, pass the ring on the end of the riser(middle ring) through the large harness ring fromabove. Fold it back toward the canopy and risers.3. Thread the smallest ring through the middlering in the same way, but make sure it doesn’tpass through the large ring as well.A) Rigs without an RSL: each yellow cable shouldextend about 6 inches (15.2 cm) past thehousing ending.B) Rigs with an RSL: the right (RSL) side yellowcable should extend 7½ inches (19.1 cm) pastthe housing ending. The left (non RSL) sideshould extend 5½ inches (14 cm) past thehousing ending.
