United Parachute Technologies Vector 3 Owner's Manual
                                                                                                       | |
Contents
| 
VECTOR 3 M A N U A LMAN‐004 REV 7.2 49 7/20/2017MAIN CANOPY ASSEMBLY AND PACKING PROCEDURESINTRODUCTIONThe Vector 3 is compatible with almost every ram‐air canopy in use today. The Vector 3 is available with a variety ofmain container sizes. Consult with the United Parachute Technologies or your dealer to ensure compatibility betweenthe pack volume of your main canopy and your Vector 3. Failure to follow manufacturer’s recommendations regardingproper canopy sizing (i.e., using oversized or undersized canopy volumes) may create a situation such as a pilot‐chute‐in tow or a premature opening of the main container.This manual does NOT provide specific packing instructions for the various main canopies on the market. It is theresponsibility of the owner to obtain canopy packing information from the canopy owner’s manual. This manual doesinclude the steps necessary to pack your canopy from the point it is inside the main deployment bag until thecontainer is closed and pilot chute is packed. There is also an included section on “Pro packing” the main canopy.ATTACHING THE MAIN CANOPY TOTHE MAIN RISERSCarefully inspect the main canopy for wear ormanufacturing defects. Attach the main canopy tothe main risers (included with the Vector 3)following the canopy manufacturer’s instructions.Double‐check the orientation of the canopy and thecontinuity of the lines. Check that the links aretightened securely and correctly. Leaving the risersattached to the harness while attaching the canopywill help minimize confusion.USING SOFT LINKSFollow manufacturer’s instructions on installation of the soft links.USING RAPIDE LINKSIf the canopy uses Rapide links, make sure the barrel nuts completely cover the threads. After hand tightening, turnthe barrel ¼ turn with the proper sized wrench.ATTACHING THE MAIN STEERING TOGGLESIt is important to note that Spectra lines (sometimes referred to as “Microline”) and Vectran lines require a differentmethod of toggle attachment than that of Dacron lines. Incorrect toggle attachment to a canopy that has Spectra linesmay result in the lines slipping out of the knot and toggle detachment. This situation may require a cut‐away andreserve deployment, or cause something more serious. If there is any question about the type of line the main canopyutilizes, refer to the canopy owner’s manual, consult a rigger, or contact your canopy manufacturer directly.The Vector 3 is supplied with steering toggles for the main canopy that are compatible with the Vector 3 risers. It isimportant that the toggles and risers be compatible to decrease the risk of associated malfunctions. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine