VDO CONTISYS OBD - V3.0 Instruction Manual

Also see for CONTISYS OBD -: Brochure Manual Quick reference guide Quick reference guide Instruction manual

FastCheck23FastCheck ABSConnectionUsing the Vehicle Application List on the CD-ROM, identify the required interface cablefor the vehicle system to be tested. Connect the cable to the service tool and securethe fixing screws.Note: If the vehicle being tested is a BMW with a 20 pin connector and an EOBD(J1962) connector, you must only use the 20 pin connector.Note: The Multiplexer cable (A2C59512985) or the CAN converter (A2C59512664)harness must be used for any diagnostics on the following vehicles:• BMW 1 series (E81/E87)• BMW 3 series (E90/E91/E92/E93)• BMW 5 series (E60/E61)• BMW 6 series (E63/E64)• BMW 7 series (E65)• GM Opel/Vauxhall - Corsa D• GM Opel/Vauxhall - Signum• GM Opel/Vauxhall - Vectra C• GM Opel/Vauxhall - Zafira BImportant informationMercedes vehicles with Sensotronic Brake Control• Ensure that you are fully familiar with the braking system and its operation beforecommencing any work.• The Sensotronic Brake Control system must be deactivated before carrying out anymaintenance/diagnostic work on the brake system. This can be done from theservice tool menu.• Only commence work after the system has been deactivated. Upon deactivation, awarning message should appear in the instrument panel and maybe accompanied byan audible warning signal until the system is reactivated. If the warning message doesnot occur, assume that the system is not fully deactivated and DO NOT commencework.• Ensure that the Sensotronic Brake Control system is reactivated after themaintenance work has been completed.Note: The manufacturer of the service tool accept no responsibility for any accident orinjury arising from the maintenance of the Sensotronic Brake Control system.