2 To move in the list of values, use the arrow buttonsUp and Down. STOP READY I/OM 3.12.1.3.1ID:DaysMondayTuesdayWednesdayThursdayFridaySunday3 To add a value into your selection, select the boxthat is next to it with the arrow button Right. STOP READY I/OM 3.12.1.3.1ID:DaysMondayTuesdayWednesdayThursdayFridaySunday3.2.2 RESETTING A FAULTTo reset a fault, you can use the Reset button or the parameter Reset Faults. See theinstructions in 11.1 A fault comes into view.3.2.3 THE FUNCT BUTTONYou can use the FUNCT button for 4 functions.• To have an access to the Control page.• To easily change between the Local and Remote control places.• To change the rotation direction.• To quickly edit a parameter value.The selection of the control place determines from where the AC drive takes the start andstop commands. All the control places have a parameter for the selection of the frequencyreference source. The Local control place is always the keypad. The Remote control place isI/O or Fieldbus. You can see the current control place on the status bar of the display.It is possible to use I/O A, I/O B and Fieldbus as Remote control places. I/O A and Fieldbushave the lowest priority. You can make a selection of them with P3.2.1 (Remote ControlPlace). I/O B can bypass the Remote control places I/O A and Fieldbus with a digital input.You can make a selection of the digital input with parameter P3.5.1.7 (I/O B Control Force).The keypad is always used as a control place when the control place is Local. Local controlhas higher priority than Remote control. For example, when you are in Remote control, ifparameter P3.5.1.7 bypasses the control place with a digital input, and you make a selectionof Local, Keypad becomes the control place. Use the FUNCT button or P3.2.2 Local/Remoteto change between the Local and Remote control.USER INTERFACES VACON · 69LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/ 3
